C180

Drivers

C180 Firmware 1.15-02 Upgrade complete with Instructions and Upgrader. UnZip directly to the C drive C:\
Download

C180 Print Driver v3.06-05 for all 64 bit versions of Windows. With C180 on and connected to PC, double click .exe file for automatic installation and configuration.
Download

C180 Print Driver v3.72-06 for all 32 bit versions of Windows. With C180 on and connected to PC, double click .exe file for automatic installation and configuration.
Download

Instructions

Smart Center on C180
Download

How to install a non exe (older) C180 Print Driver on a 32 or 64 Bit OS PC via USB Connection.
Download

C180 UserManual
Download

Manual Focus Tool Chart
Download

Proper Location of Lens in the Lens Carriage
Download

C180 X and Y Flag CDR file. Use 1/16″ engraving stock to cut the flags. Do not use clear material.
Download

Directions on how to replace the X motor on a C180
Download

How to Upgrade the Firmware on a C180
Download

How to manually fire the laser for a Laser Power Meter Test
Download

How to install the old (non .exe versions) of the Print Driver on a 32 or 64 Bit OS PC via USB
Download

LaserPro DirectPrint MAC AI Plug-In User Manual CSX
Download

Photo of the X Flag. If yours had been broken off, download the CDR file to create a new one. The flag file varies by model. Please insure you download the flag file from the correct machine page in support.
Download

Instructions on how to install and configure your LaserPro Print driver, and USB port connection.
Download

Movies

Instructions for proper cleaning of the Mirrors and Lenses. Remember there are 4 mirrors, at least 1 Focus lens, and an optic on the end of the actual laser. The red beam mirror requires no special attention and is not counted as one of the above 4 mirrors. The mirrors are gold plated silicone and should be treated very carefully to avoid damage. The only way to damage a laser optic is by not cleaning when dirty, or by cleaning improperly.
Download

How to use the Rotary Attachment using Center Home. Part 1 the Software setup portion.
Download

How to use the Rotary Attachment using Center Home. Part 2 the Hardware setup portion. Your model may be different then shown, but the instructions are the same for all models.
Download

How to release, and seat the X Motor Cable Connection for X PCB and Main Board.
Download

Power Settings

Power and Speed Starting Point for various materials for all models and wattage’s.
Download