Mercury III Firmware Complete version 1.06-01. Extract to C Drive, and it will make a folder called LaserPro. Instructions and all required will be in the folder.
Download
Mercury III Firmware 3_05_03 for New (Red Color) Main Boards only. If your MB is Green use the other Firmware File.
Download
Mercury III Print Driver v4.07-03 for all versions of Windows. With Mercury III on and connected to PC, double click .exe file for automatic installation. See instructions below “Instructions on how to install and configure your LaserPro Print driver for” USB or Ethernet.
Download
Manual Focus Tool Chart
Download
Mercury X and Y Flag CorelDRAW File
Download
Mercury X Flag Photo
Download
Beam Alignment instructions
Download
How to manually fire the laser for a Laser Power Meter Test
Download
Adjusting Laser Tickle Pulse. This will need to be done if at the extreme beginning, and end of the raster passes, a single pixel is visible on your material. This effect is most noticeable on Gold and Black engraving plastic.
Download
How to install the old (non .exe versions) of the Print Driver on a 32 or 64 Bit OS PC via USB
Download
How to set Origin with the Red Beam as a reference
Download
How to set Origin with Calipers. Only use Red Beam method if you do not have calipers for precision measurement.
Download
Mercury III User Manual. Do not operate machine without reading complete manual.
Download
How to Upgrade the Firmware. These instruction will also be in the firmware download once unzipped.
Download
LaserPro DirectPrint MAC AI Plug-In User Manual CSX
Download
Instructions on how to install and configure your LaserPro Print driver, and USB port connection.
Download
Instructions on how to install and configure your LaserPro Print driver when connected via Ethernet port connection.
Download
Instructions for proper cleaning of the Mirrors and Lenses. Remember there are 4 mirrors, at least 1 Focus lens, and an optic on the end of the actual laser. The red beam mirror requires no special attention and is not counted as one of the above 4 mirrors. The mirrors are gold plated silicone and should be treated very carefully to avoid damage. The only way to damage a laser optic is by not cleaning when dirty, or by cleaning improperly.
Download
How to use the Rotary Attachment using Center Home. Part 1 the Software setup portion.
Download
How to use the Rotary Attachment using Center Home. Part 2 the Hardware setup portion. Your model may be different then shown, but the instructions are the same for all models.
Download
How to release, and seat the X Motor Cable Connection for X PCB and Main Board.
Download
Copyright © 2020 LaserproNA.com All rights reserved. Terms of Use | Privacy Policy